Micro-Fine Ultra Pen Needles 32G x 4MM 100 Pack
Micro-Fine Ultra Pen Needles 32G x 4MM 100 Pack
What 500,000+ customers say about medino:
Description
BD Micro-Fine Ultra Pen Needles 32G x 4MM 100 Pack are sterile, single-use pen needles from embecta (formerly BD) for use with compatible pen injection devices. Each needle is 4mm long and 32G, and the pack contains 100 needles.
Key Features
- 4mm length: The 4mm needle helps reduce the risk of intramuscular injection compared with needles of 6mm and longer.
- 5-bevel tip: The needle has a 5-bevel tip, which can bring a more comfortable and less painful injection.
- Ultra-thin wall: The ultra-thin wall technology increases flow, so less thumb pressure is needed on the pen button.
- Fits widely used pens: The needles are compatible with widely used pen injection devices, so a change in pen does not necessarily mean changing needles. Check the instructions supplied with your pen.
- Sterile and single use: Each needle is intended for one use only, and a new needle should be used for every injection.
Is the BD Micro-Fine Ultra 4mm pen needle the same as BD Ultra-Fine?
embecta, formerly part of BD, now makes this needle. Older listings may use the BD Ultra-Fine or BD Micro-Fine+ names. Check the product code on your pack if you need an exact match.
Can I reuse a pen needle?
No. The pen needles are intended for single use and are no longer sterile after one use. It links reuse to injection pain and bleeding, and recommends a new needle for every injection.
Will these needles fit my pen?
The needles are compatible with widely used pen injection devices. Check the instructions supplied with your injection pen to confirm.
What do 32G and 4mm mean?
32G is the needle gauge, a measure of how thick the needle is, and 4mm is the needle length. A higher gauge number means a thinner needle.
Usage and Instructions
- Wash your hands.
- Remove the peel tab and push the new needle straight onto the pen. Do not put it on at an angle. Screw it on tight.
- Remove the outer cover and keep it for disposal after the injection, then remove the inner needle shield and discard it.
- Check the flow of insulin by dialling 2 units and injecting into the air until you see a drop. Repeat if no drop appears.
- Dial your dose.
- Inject straight in. Push the thumb button and count for up to 10 seconds before removing the needle straight out of the skin.
- If you need to recap, place the outer cover on a flat surface and push the needle straight down into it with one hand. Unscrew the needle from the pen.
- Dispose of the pen needle straight away in a suitable sharps container.
Rotate injection sites and inject at least one finger width away from your last injection. The usual areas are the abdomen, thighs, arms and buttocks.
Warnings
Please note the following:
- Remove both the outer cover and the inner needle shield before injecting. If either is left on, the medication or dose may not be injected, which may result in serious injury or death.
- Use a new pen needle for every injection. Pen needles are no longer sterile after one use, and reuse is associated with injection pain or bleeding.
- Dispose of used needles straight away in a sharps container.
- Talk to your diabetes care team or pharmacist about injection technique and the best injection areas for you.